BOWTECH Posted April 6, 2013 Share Posted April 6, 2013 I'm planning on installing the x4 on a 27 foot tiara with twin screws,looking for some suggestions where to locate the transducer. Any help would be appreciated. Link to comment Share on other sites More sharing options...
Nailer Posted April 7, 2013 Share Posted April 7, 2013 Jason, welcome to the site. Link to comment Share on other sites More sharing options...
BOWTECH Posted April 7, 2013 Author Share Posted April 7, 2013 Thank you Ken! Link to comment Share on other sites More sharing options...
Boss Hawg Posted April 7, 2013 Share Posted April 7, 2013 Just try and keep it clean of wash as much as possible but really they incredibly picky I would try to separate it from other transducers but not life or death or and I know this probably goes without saying but somewhat close to the rigger u plan on using. Link to comment Share on other sites More sharing options...
BOWTECH Posted April 7, 2013 Author Share Posted April 7, 2013 Thank you for the help Josh,we plan on installing it today. Link to comment Share on other sites More sharing options...
SeaCatMich Posted April 7, 2013 Share Posted April 7, 2013 As long as you don't mount it right behind one of the props or on a strake on the hull, it probably doesn't matter too much where it is on the transom. Unlike a depth sounder transducer you don't use most features of the FishHawk all that much until trolling. Surface temp can be used when on plane to find surface breaks but 90% of the time you use it going slow. Consequently air turbulence gong over the transducer isn't a big problem. On I/O or O/B boats I usually put the depth sounder transducer on the starboard side and the Fishhawk on the port. With the prop direction going clockwise when viewed from off the stern, the prop wash created on starboard side is down away from the hull while the port side is coming up toward the hull (and any transducer mounted there). Since the FishHawk is a receive only transducer it is better off on the noisy side. On an inboard, not a clue... but maybe that will help you figure out if one location would be better than another. As for distance from the downrigger, I have used my X4 probe on both of my outdown riggers but primarily on my starboard rear. On my 8.5' beam boat it worked well in all locations. The real advantage of mounting it near the primary downrigger it will be used on is routing the cable from the transducer to the display... if the display is going near the downrigger. If it's going at the helm, then cable routing for the connection might still be a factor and on most boats that still points toward a starboard location. Link to comment Share on other sites More sharing options...
BOWTECH Posted April 7, 2013 Author Share Posted April 7, 2013 Awesome advice Ryan thank you for the detailed info,that's what I was hoping for when I posted. We are hoping to get the boat wet ASAP. Link to comment Share on other sites More sharing options...
Rascal Trophy Fishing Posted April 7, 2013 Share Posted April 7, 2013 Thanks for joining Jason, do let us know how the X-4 situation comes out in the end. Link to comment Share on other sites More sharing options...
Paulywood Posted April 7, 2013 Share Posted April 7, 2013 Welcome to GLF Jason! Link to comment Share on other sites More sharing options...
EdB Posted April 13, 2013 Share Posted April 13, 2013 Welcome Jason! Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now