Shift Cable/ Trim Sensor /Bellow Replacement

[N II Deep]

Looking to see if some one in the Grand Rapids area has a Mercuriser hinge pin tool that I could use for a few days.

I am replacing the shift cable, all bellows, and trim sensor this week.

Hope to be on the water the following weekend.

[jimbobber]

if your hinge pins arent in to tight you can use an allen wrench. This was some info given to me by my mecanic as i do not have one either.otherwise you can get one on ebay for 20 bucks i think.

[Vitalidle]

If nobody has one for your use local I can lend you mine. Obviously would have to send it to you through the mail. I no longer have a mercruiser, so its just collecting dust right now. Let me know I don't mind sending it out to you. Also I have a brand new trim and tilt sender switches for the drive. If you haven't purchased already you can have them as I have no use for them as well:thumb:

[N II Deep]

Sean

Send me a pm on how much you need for the trim parts

If nobody has one for your use local I can lend you mine. Obviously would have to send it to you through the mail. I no longer have a mercruiser, so its just collecting dust right now. Let me know I don't mind sending it out to you. Also I have a brand new trim and tilt sender switches for the drive. If you haven't purchased already you can have them as I have no use for them as well:thumb:

[Vitalidle]

Pm sent.

[Priority1]

Jon, Jimbobber is right about the tool. I did mine 3 years ago and a allen wrench did the job. It is a larger size wrench that I happened to have.

[2UNREEL]

I have the hinge pin tool, send me a pm if you need to borrow it. I would not use an allen wrench for this job could get nasty otherwise.

[N II Deep]

I have one coming from Sean (Vitalidle) on loan thanks guys for your help.

again this is what makes this a great site to hang out on. being able to help each other out.

[Vitalidle]

Pm sent. Everything is on its way Jon